Entering The Password; Installing Or Changing The Password - Teledyne 2010A Operating Instructions Manual

Thermal Conductivity Analyzer
To install a new password or change a previously installed password, you
must key in and ENTER the old password first. If the default password is in
effect, pressing the ENTER button will enter the default TAI password for you.
Press System to enter the System mode.
Contrast Function is DISABLED
(Refer to Section 1.6)
Use the < > arrow keys to scroll the blinking over to
Enter to select the password function. Either the default TAI password or AAA
place holders for an existing password will appear on screen depending on
whether or not a password has been previously installed.
The screen prompts you to enter the current password. If you are not using
password protection, press Enter to accept TAI as the default password. If a
password has been previously installed, enter the password using the < > arrow
keys to scroll back and forth between letters, and the Δ Δ Δ Δ Δ ∇ arrow keys to change
the letters to the proper password. Press Enter to enter the password.
In a few seconds, you will be given the opportunity to change this pass-
word or keep it and go on.
Press Escape to move on, or proceed as in Changing the Password,
below.
If you want to install a password, or change an existing password, proceed
as above in Entering the Password. When you are given the opportunity to
change the password:
Press Enter to change the password (either the default TAI or the previ-
ously assigned password), or press Escape to keep the existing password and
move on.
4.3.3.1

Entering the Password

CONTRAST AUTO—CAL
PWD LOGOUT MORE
Enter password:
T A I
or
Enter password:
A A A
Change Password?
<ENT>=Yes
4.3.3.2

Installing or Changing the Password

Change Password?
<ENT>=Yes
Teledyne Analytical Instruments
Part I: Control Unit
, and press
PWD
<ESC>=No
<ESC>=No
Part I 4-7