1 Introduction
• Power Connection
• Analog Outputs
Alarm Connections
•
• RS-232 Port
• Remote Probe
• Remote Span/Zero
• Calibration Contact To notify external equipment that in-
• Range ID Contacts
• Network I/O
Note: If you require highly accurate Auto-Cal timing, use external
1- Part
Figure 1-: Model 010A Rear Panel
85-250 V AC power source.
0-1 V dc concentration plus 0-1 V dc
range ID, and isolated 4-20 mA dc plus
4-20 mA dc range ID.
2 concentration alarms and 1 system
alarm.
Serial digital concentration signal out-
put and control input.
Used in the 2010A to interface the ex-
ternal Analysis Unit.
Digital inputs allow external control of
analyzer calibration.
strument is being calibrated and read-
ings are not monitoring sample.
Four separate, dedicated, range-identifi-
cation relay contacts (01, 02, 03,CAL).
Serial digital communications for local
network access. For future expansion.
Not implemented at this printing.
Teledyne Analytical Instruments
Model 2010A