Ending A Conference And Placing All Parties On Hold; Using Record-A-Call - Mitel 5304 User Manual

Ending a Conference and Placing all Parties on Hold

You can end a conference and place all conference parties on Individual Hold, allowing you to
toggle between the held parties and speak to one party at a time.
To end a conference and place all parties on Individual Hold:
1. Press the Special button, and then dial 5.
2. Press the Hold button. CONFERENCE PARTIES ON HOLD appears.
To toggle between the held callers:

Using Record-A-Call

You can use Record-A-Call to record an ongoing call as a mailbox message.
retrieve the message from your voice mailbox. The Record-A-Call feature stays active after the
other party hangs up, so you can add your own message to the recorded call.
NOTE
To use Record-A-Call:
1. While on a call, press the Special button, and then dial 385. REQUESTING RECORD-
2. Enter the voice mailbox number where you want the recording to be saved.
To stop Record-A-Call:
1.
Mitel ® 5304 IP Phone User Guide – Issue 2, June 2010
Press the Hold button twice for internal parties or the applicable Call button for external
parties.
Record-A-Call is not supported on peer-to-peer (P2P) calls. Contact your system
administrator for more information.
A-CALL appears.
RECORD-A-CALL IN PROGRESS appears, and both you and the calling party hear a
confirmation tone (if enabled).
If your system administrator assigns the Record-a-Call voice mailbox
NOTE
destination, you do not need to enter the voice mailbox number.
Do one of the following:
•
Press the Special button, and then dial 385.
•
Hang up.
This feature may or may not be enabled for your system.
Call Features
1
You can then
Page 37