Copying From The Bypass Tray - Ricoh IS 2060 Operating Instructions Manual

Copying

Copying from the Bypass Tray

Use the bypass tray to copy onto spe-
cial paper (OHP transparencies, label
paper (adhesive labels), thick paper
(for example postcards and enve-
lopes), thin paper), and copy paper
2
that cannot be loaded in the paper
trays.
Preparation
When copying from the bypass
tray, select [1 Sided→ → → → 1 Sided] for
copying in [Dup./Combine/Series].
You can change the initial settings.
⇒ p.101 "Duplex Mode Priority"
Important
❒ When paper larger than 433 mm in
size is used, the paper may become
wrinkled, may not be fed into the
machine, or may cause paper jams.
❒ When copying onto special paper,
such as adhesive labels, be sure to
select "Face up" in ⇒ p.109 "Eject
Copy Face Up/Down in Bypass
Mode". If you select "Face Down",
a paper misfeed may occur.
Note
❒ The sizes of paper you can use
with the bypass tray are as follows.
Metric
version
Inch
version
❒ The machine can automatically de-
tect the following sizes as standard
size copy paper.
Metric
version
Inch
version
20
• Vertical: 100 – 305mm
• Horizontal: 139.7 – 600mm
• Vertical: 3.9" – 12.0"
• Horizontal: 5.5" – 23.6"
L , A4 L , A5 L , 100 ×
A3
148mm
L , 11" × 17" L , 8 " ×
1
A3 /
2
" × 8 L , 100 ×
1 1
L , 5
14" / / "
2 2
148mm
❒ If you want to use the size of paper
other than ones in the above table,
be sure to specify the size. ⇒ p.21
"When copying onto standard size
paper", ⇒ p.83 "Program"
❒ When copying on OHP transpar-
encies or paper heavier than 105
2
g/m (about 27.9 lb.), you need to
specify the paper type. ⇒"Paper
Type"in the General Settings
Guide
❒ If you want copies to be delivered
face down when placing the origi-
nals on the exposure glass, select
"Face down" for both"Eject Copy
Face Up/Down in Glass Mode"
and "Eject Copy Face Up/Down in
Bypass Mode" of the User Tools.
❒ If you have selected OHP transpar-
encies or thick paper paper in
"Special paper", you cannot make
copies to be delivered face down.
❒ The maximum number of sheets
you can load into the bypass tray
depends on the paper type. The
m a x i m u m n u m b e r o f s h e e t s
should not execeed the upper lim-
it.
A A A A
Open the bypass tray.