If You Cannot Make Copies As You Want - Ricoh IS 2060 Operating Instructions Manual

If You Cannot Make Copies As You Want

This section explains causes and remedies when copy results are not as expect-
ed.
Problem
Copies are not stapled.
Staples are wrongly posi-
tioned.
Paper jams occur frequent-
ly.
You cannot combine sever-
al functions.
When sorting, the pages
are divided into two
blocks.
In Double Copies mode,
parts of the original image
are not copied.
In Border, Center, or Cent-
er/Border mode, parts of
the original image are not
copied.
Cause
There are jammed staples
in the stapler.
The number of copies ex-
ceeds the capacity of the
stapler.
Copy paper is curled.
Originals are not set cor-
rectly.
The paper size is not cor-
rect.
Selected functions cannot
be used together.
The memory became full in
the middle of sorting and
the pages were delivered in
two blocks.
Combination of original
and copy paper is not cor-
rect.
You set a wide erased mar-
gin.
Originals are not scanned
correctly.
If You Cannot Make Copies As You Want
Action
Remove jammed staples. ⇒ "
moving Jammed Staple" in the Gen-
eral Settings Guide
Note
❒ After removing jammed staples,
staples might not be ejected the
first few times you try to use the
stapler.
Check the stapler capacity. ⇒ p.35
"Staple"
Turn the copy paper over in the
tray.
Check the correct position to place
the originals. ⇒ p.35 "Staple"
Set the correct paper size. ⇒
"Changing the Paper Size"in the
General Settings Guide
Check the combination of functions
and make the settings again.
Reference
⇒ p.111 "Combination Chart"
You can interrupt copying when the
memory becomes full. ⇒ p.108
"Memory Full Auto Scan Restart"
L for A4 K originals and
Select A3
A4 for A5 originals (when using a
100% ratio).
Make the margin width narrower.
You can adjust it between 2–99mm.
⇒ p.103 "Erase Border Width" and
⇒ p.104 "Erase Center Width"
Set the originals correctly.
e Re-
4
87