Table of Contents
Advertisement
Troubleshooting
Problem
In Margin Adjustment
mode, parts of the original
image are not copied.
In Image Repeat mode, the
original image is not cop-
ied repeatedly.
The stamp position is
wrong.
4
When Combine, parts of
the image are not copied.
Order of copies is not cor-
rect.
When Duplex, copy is
made Top/Bottom even
though Left/Right is se-
lected, or copy is made
Left/Right even though
Top/Bottom is selected.
Paper does not output dur-
ing printing with stapling.
88
Cause
You set a wide erased mar-
gin.
There is a lack of margin
space on the opposite side
of the binding position.
You selected copy paper
the same size as the origi-
nals, or you did not select
the proper reproduction
ratio.
The paper orientation is
wrong.
You specified a reproduc-
tion ratio that does not
match the sizes of your
originals and copy paper.
You placed the originals in
the incorrect order.
You placed the originals in
the wrong direction.
When you stop printing
while using the staple func-
tion, papers not stapled
during printing may be left
in the staple unit.
Action
Set a narrower margin with the User
Tools. ⇒ p.103 "Front Margin:
Left/Right", ⇒ p.103 "Front Mar-
gin: Top/Bottom", ⇒ p.103 "Back
Margin: Left/Right", ⇒ p.103 "Back
Margin: Top/Bottom"
Select copy paper larger than the
originals.
Select the proper reproduction ratio.
Check the paper orientation and
stamp position.
When you specify a reproduction
ratio using Manual Paper Select
mode, make sure that the ratio
matches your originals and the copy
paper.
Note
❒ Select the correct reproduction
ratio before using Combine
mode.
When placing a stack of originals in
the document feeder, the last page
should be on the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
Place the originals in the correct ori-
entation. ⇒ p.10 "Original Orienta-
tion"
{ { { { Reset } } } } key and cancel
Press the
copy settings, including stapling.
Advertisement
Table of Contents
