5.
Unplug the cable from the connector on the QuickFind diagnostic board and remove the
board from the chassis.
Figure 4-45 Removing and Replacing the QuickFind Diagnostic Board
Replacing the QuickFind Diagnostic Board
To replace the QuickFind diagnostic board, follow these steps:
1.
Gently plug the cable into the QuickFind diagnostic board connector.
2.
Replace the QuickFind diagnostic board into the cover by snapping it into place.
3.
Turn the assembly over and snap into place on top of the power supply cage.
4.
Replace the top cover. See
5.
If rack mounted, slide the server into the rack until it stops. See
the Rack" (page
Figure 4-45
shows how to remove the QuickFind diagnostic board.
"Replacing the Top Cover" (page
32).
Removing and Replacing the QuickFind Diagnostic Board
36).
"Inserting the Server into
93