Single-User Mode Hp-Ux Booting; Booting Hp-Ux In Single-User Mode (Efi Shell) - HP Integrity rx4640 Service Manual

5. Exit the console and iLO MP interfaces when finished using them.
To exit the system console and return to the iLO MP Main Menu, press Ctrl+B. To exit the
iLO MP, enter X at the Main Menu.

Single-User Mode HP-UX Booting

Use the following procedure to boot HP-UX in single-user mode.

Booting HP-UX in Single-User Mode (EFI Shell)

From the EFI Shell environment, boot in single-user mode by stopping the boot process at the
HPUX.EFI interface (the HP-UX Boot Loader prompt, HPUX>) and entering the boot -is
vmunix command.
1. Access the EFI Shell environment for the system on which you want to boot HP-UX in
single-user mode.
To choose the system console, log in to the iLO MP and enter CO.
When accessing the console, confirm that you are at the EFI Boot Manager menu (the main
EFI menu). If you are at another EFI menu, choose Exit from the submenus until you return
to the screen with the EFI Boot Manager heading.
to access the EFI Shell environment, choose EFI Shell from the EFI Boot Manager menu.
2. Access the EFI System Partition (fsX: where X is the file system number) for the device
from which you want to boot HP-UX.
3. When accessing the EFI System Partition for the desired boot device, issue the HPUX command
to initiate the \EFI\HPUX\HPUX.EFI loader on the device you are accessing.
4. Boot to the HP-UX Boot Loader prompt (HPUX>) by pressing any key within the 10 seconds
given for interrupting the HP-UX boot process. Use the HPUX.EFI loader to boot HP-UX
in single-user mode in the next step.
After you press a key, the HPUX.EFI interface (the HP-UX Boot Loader prompt, HPUX>)
launches. For help using the HPUX.EFI loader, enter the help command. To return to the
EFI Shell, enter exit.
fs0:\> hpux
(c) Copyright 1990-2002, Hewlett Packard Company.
All rights reserved
HP-UX Boot Loader for IA64
Press Any Key to interrupt Autoboot
\efi\hpux\AUTO ==> boot vmunix
Seconds left till autoboot -
[User Types A Key to Stop the HP-UX Boot Process and Access the HPUX.EFI Loader ]
Type
HPUX>
5. At the HPUX.EFI interface (the HP-UX Boot Loader prompt, HPUX>) enter the boot -is
vmunix command to boot HP-UX (the /stand/vmunix kernel) in single-user (-is) mode.
HPUX> boot -is vmunix
> System Memory = 4063 MB
loading section 0
................................................... (complete)
loading section 1
........ (complete)
loading symbol table
loading System Directory(boot.sys) to MFS
....
loading MFSFILES Directory(bootfs) to MFS
......
Launching /stand/vmunix
Revision 1.723
9
help for help
Booting and Shutting Down HP-UX 121