Replacing The Dvd I/O Board; Removing And Replacing The Dvd I/O Board - HP Integrity rx4640 Service Manual
Hide thumbs
Also See for Integrity rx4640:
- Operation and maintenance manual (232 pages) ,
- User's & service manual (197 pages) ,
- Operation manual (90 pages)
Table of Contents
Advertisement
Figure 4-43 Removing and Replacing the DVD I/O Board
8.
Unfasten the release clip attaching the DVD I/O board to the chassis, and remove the I/O
board from the chassis.
9.
Lift out the DVD I/O board.
10. Remove the midplane riser board connector cable and remove the DVD I/O board from the
chassis.
Replacing the DVD I/O Board
To replace the DVD I/O board, follow these steps:
1.
Replace the DVD I/O board into the chassis and plug in the midplane riser board connector
cable.
2.
Replace DVD I/O board to the chassis by refastening the release clip.
3.
Replace the cover plate using the two torx #15 screws and a torx #15 driver.
4.
Replace the processor extender board. See
(page
44).
5.
Replace the memory extender board. See
"Replacing the Processor Extender Board"
"Replacing the Memory Extender Board" (page
Removing and Replacing the DVD I/O Board
38).
89
Advertisement
Table of Contents
Troubleshooting
