Baud; Syntax; Parameters; Operation - HP Integrity rx4640 Service Manual

Example C-4 help cpuconfig Command
Shell> help cpuconfig
Deconfigure or reconfigure cpus
CPUCONFIG [cpu] [on|off]
cpu Specifies which cpu to configure
on|off Specifies to configure or deconfigure a cpu
Notes:
1. Cpu status will not change until next boot
2. Specifying a cpu number without a state will display
configuration status.
Examples:
* To deconfigure CPU 0
fs0:\> cpuconfig 0 off
CPU will be deconfigured on the next boot
* To display configuration status of cpus
fs0:\> cpuconfig
<CPU configuration data displayed>

baud

Sets the baud rate and communication settings for a UART.

Syntax

baud <index> <baudrate>

Parameters

<index> 0 through the total number of UARTS minus one
<baudrate>

Operation

This command is used to change the speed for a UART in the server. This command works for
all UARTs visible to EFI/POSSE. If the UART is part of processor dependent hardware (PDH)
space and is initialized by the core firmware, this command communicates the settings to core
firmware so the UART can be initialized with the new settings on the next boot. Server default
is 9600 baud.
Other Communication parameters are listed in
Table C-2 Communications Parameters
Parameter
RECEIVE_FIFO_DEPTH
TIMEOUT
PARITY
DATA_BITS
STOP_BITS
CONTROL_MASK

boottest

Interacts with the speedy boot variable allowing it to be set appropriately.
Syntax
boottest
boottest on
boottest off
138 Utilities
baud rate.
Value
1
1000000
No parity
8
1
0
Displays status of all speedy boot bits
Run all tests (for a normal boot time)
Skip all tests (for a faster boot time)
Table C-2.