Fastptcp Event Messages - HP Spooler FASTP Manual

Installing and Configuring FASTP Network Print
Processes

If a processor fails, the Spooler supervisor only restarts the process (and any failed
jobs) automatically if the Spooler RESTART parameter was specified as non-zero
for the devices controlled by the FASTP network print process. In this case, the
Spooler supervisor does not wait for the RESTART interval to elapse.

Most FASTP network print processes report other unexpected errors in text form to
$0. Beginning with the G06.10 and D48.02 RVUs of FASTPTCP, FASTPTCP
generates tokenized event messages on the $0 collector. (Note: as a temporary
measure to allow users time to adjust their EMS filters, the ASCII 512 text
messages can be written instead by setting bit 15 (%1) in the Spoolcom PRINT
PARM command.) For descriptions of all the messages generated by the FASTP
network print processes, including the FASTPTCP event messages, see
Appendix B, EMS

Beginning with the G06.10 and D48.02 RVUs, you can also enable debugging
features, disable event messages, and generate detailed EMS events for
FASTPTCP by setting bit 1 (%40000) and bit 14 (%2) in the Spoolcom PRINT
PARM command. For details, see

Errors that indicate an internal-logic error cause the FASTP network print process
to abend. Unless the SAVEABEND option has been disabled in the BIND, an
abend always creates a SAVEABEND file. SAVEABEND dumps generally indicate
a serious problem and should be forwarded to your service provider for analysis.
Spooler FASTP Network Print Processes Manual — 427528-006
Messages.
PRINT PARM Attribute
2 - 42
Error-Handling Considerations
on page 3-10.