Installing And Adjusting The Cinewide Anamorphic Lens; Attach Lens Mounting Assembly To Lens Motor Carriage Plate; (Cinewide With Autoscope) Or Base Plate (Fixed Cinewide) - Runco NLMP22109 Installation & Operation Manual

3.11
Installing and
Adjusting the
CineWide Anamorphic
Lens
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate (CineWide
with AutoScope) or Base
Plate (fixed CineWide)
If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
Note
➤
The VX-22i Anamorphic lens mount kit consists of everything shown in Figure 3-18. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23RUNCO.
Anamorphic Lens
10
Set Screw
9
Pitch Adjustment
T-Nut (2x)
Yaw/X Adjustment
8
Lever (2x)
Figure 3-18. VX-22i Anamorphic Lens Mounting Assembly - Exploded View
1. Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Lens Adapter Ring and
1
Mounting Screws (3x)
38
2 Pitch Adjustment Yoke for Lens
3
Height/Y Adjustment
T-Screw and Washer
(2x)
4
5
Anamorphic Lens
Holder
6 1/4-20 Hex Bolt (2x)
and Washer (2x)
7
AutoScope Carriage Plate or
Fixed CineWide Base Plate
Runco VX-22i Installation/Operation Manual
Pitch Adjustment
T-Screw and
Washer (2x)