Installing And Adjusting The Cinewide Anamorphic Lens; Anamorphic Lens Installation And Adjustment - Rs-1100 Ultra/Cinewide With Autoscope; Rs-1100 Ultra Anamorphic Lens Mounting Assembly - Exploded View - Runco RS-1100 CineWide Owner's Operating Manual

If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
It is extremely important that the primary lens is properly
Note
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
The standard RS-1100/CineWide uses a prismatic-style anamorphic lens. This type of
lens compresses the height of the image (as opposed to stretching the width) to achieve a
2.35:1 aspect ratio with a 1.78:1 display device.
The RS-1100 Ultra/CineWide and RS-1100 Ultra/CineWide with AutoScope use a
cylindrical anamorphic lens with a much larger aperture than the prismatic lens used with
the standard RS-1100/CineWide.
If you are installing a standard RS-1100/CineWide or RS-1100 Ultra/CineWide, refer to
Anamorphic Lens Installation and Adjustment - Standard RS-1100/CineWide or
RS-1100 Ultra/CineWide on page 38. If you are installing an RS-1100 Ultra/CineWide
with AutoScope, continue with the next section.
The RS-1100 Ultra Anamorphic lens mount kit consists of everything shown in Figure
3-16. Some components shipped with your projector may differ slightly from what is
shown in these instructions.
8 Yaw/X Adjustment
Levers (2) and
Washers (2)
Figure 3-16. RS-1100 Ultra Anamorphic Lens Mounting Assembly - Exploded
View
Runco RS-1100 Series Owner's Operating Manual
Anamorphic Lens Mount
1
6
AutoScope Carriage Plate
7
33
Pitch Adjustment Yoke
2
for Lens
Height/Y Adjustment
3
T-Screw (2)
and Washer (2)
Pitch Adjustment
4
T-Screw (2)
and Washer (2)
Anamorphic Lens
5
Holder
1/4-20 Hex Bolts (2)
Installation
3.11
Installing and
Adjusting the
CineWide Anamorphic
Lens
Anamorphic Lens
Installation and
Adjustment - RS-1100
Ultra/CineWide with
AutoScope