Connect The Power Cord; Turn The Projector On; Select A Source; Adjust Image - Runco Video Xtreme VX-40d Owner's Operating Manual

Connect the Power Cord

The North American rated power cord is provided with each projector.
Plug the power cord to the AC receptacle located on the right hand side of the projector
and the 3-pronged end into a grounded AC outlet. The input voltage to the projector
must be capable of 100 – 240 VAC in 1000W models (VX-40d and VX-60d) and 200-
240VAC in 1200W models (VX-50d and VX-80d). (See also Section 6 – Specifications for
complete details on all power requirements.)
Use the approved North American-rated power cord supplied with the projector. If you are
connecting to an area outside of North America make sure you are using an appropriately
rated power cord.

Turn the Projector ON

Press the POWER button on either the remote or built-in keypad to turn the projector
on, or turn the power on the DHD Controller (after fully connecting it to the projector),
which will turn on the projector automatically. Wait a few minutes to allow the projector to
warm up. The LED status window displays an active pattern of segments to indicate the
projector is changing its state from powered down to powered up. The message "On"
appears in the display when the projector has completed its initialization and is ready for
use.

Select a Source

Press one of the input keys on the remote or built-in keypad to select and display the
image for the source. With the DHD Controller, this would be either RGB (Input 1) or DVI
(Input 2).

Adjust Image

Press Auto to initiate an automated process in which the projector optimizes critical
display parameters such as size, position, pixel tracking etc. for the source selected.
You can also access the menu system and adjust these and other image settings by
pressing on the remote.
9
Section 2: Installation and Setup
Step 4
Step 5
Step 6
Step 7