[Prov] Create/Expand Pools - HP StorageWorks P9000 - Disk Arrays Reference Manual

Example 3: Thin Provisioning
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,
Task Name,[PROV],Create LDEVs,Thin Provisioning,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{Pool ID,LDKC:CU:LDEV,LDEVCapa(blocks), Emulation,
CLPR,SSID,MP Blade ID,Result}
=[{1,0x00:0x00:0x00,96000, OPEN-V, 0,0x0004,Auto,
Normal end},
{1,0x00:0x01:0x00,96000, OPEN-V, 0,0x0005,Auto,Normal end}],
Num.of LDEVs=2
Basic Information for Example 2 and 3
Item
Snapshot
Thin Provisioning
Detailed Information for Example 2 and 3
Item
PG
LDKC:CU:LDEV
Start LBA
Emulation
Size
Unit
System Disk
MP Blade ID
Num. of LDEVs

[PROV] Create/Expand Pools

Example
07xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,RMI AP,uid=user-name,1,
Task Name,[PROV],Create Pools,,Normal end,
from=xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx,,Seq.=xxxxxxxxxx
+{Pool ID, Pool Type, Multi Tier Pool,Warning Threshold(%),
Depletion Threshold(%),Subscription Limit(%),Tier Management,
Cycle Time,Monitoring Period,Pool Result}
=[{1,Thin Provisioning,Enable,20,70,100,Auto,1,00:00-23:59,
Normal end}],Num. of Pools = 1
Description
Create LDEVs was done to virtual volumes for Snapshot.
Create LDEVs was done to virtual volumes for Thin Provisioning.
Description
The parity group number.
An E at the beginning of a parity group number designates an external volume is present in
that parity group.
The LDKC, CU, and LDEV numbers.
The start LBA.
A hyphen (-) is output when not specified.
The emulation type.
The user-specified capacity.
The unit of the CV capacity.
LBA is displayed.
This capacity value can be converted into kilobytes by dividing by two because one block is
512 bytes.
For information about how to convert the capacity value into cylinders, see the section describing
size calculation in HP StorageWorks P9000 Provisioning for Mainframe Systems User Guide.
Indicates system disk status.Enable: Enabled, Disable: Disabled
The specified MP blade ID.
"Auto" indicates the processor blade number is set automatically.
The number of LDEVs.
Provisioning Descriptions 103