Table of Contents
Advertisement
These venting systems, in combination with the L676, have been tested and listed as a direct vent heater system by Warnock Hersey. The location
of the termination cap must conform to the requirements in the Vent Terminal Locations diagram from the "Exterior Vent Termination Locations"
section.
FPI Direct Vent (Flex) System Termination Kits include all the
parts needed to install the L676 using a fl exible vent.
FPI Kit #
Length
Contains:
#946-618
6 Feet
1)
8" fl exible liner (Kit length)
2)
5" fl exible liner (Kit length)
3)
spring spacers (3)
4)
thimble (2)
5)
AstroCap termination cap (1)
6)
screws (12)
#946-616
10 Feet
7)
tube of Mill Pac (1)
8)
plated screws (8)
9)
S.S. screws #8 x 1-1/2" drill point, (4)
10) vinyl siding standoff
5" dia. flue pipe
8" dia.
Flue pipe
Regency
®
L676 Direct Vent Gas Fireplace
VENTING ARRANGEMENTS
HORIZONTAL TERMINATION (FLEX)
Regency
®
Direct Vent System
Vinyl Siding
Standoff
Wall Thimble
(Mandatory in all
Horizontal Terminations)
spring spacer
INSTALLATION
Vent Guard - if required*
(Part #946-506/P)
TM
AstroCap XL
Termination Cap
(Part #946-623/P)
* A Vent Guard is required when the AstroCap
is installed above grade at 7 feet or lower.
Notes:
1) Liner sections should be continuous
without any joints or seams.
2) Only Flex pipe purchased from FPI may
be used for Flex installations.
3) Horizontal vent must be supported every
3 feet.
4) A wall thimble is mandatory for all
horizontal terminations due to high
temperatures.
15
Advertisement
Table of Contents
