Venting Arrangements - Regency HZ54E Quick Start Manual

VENTING ARRANGEMENTS

ALLOWABLE VERTICAL TERMINATIONS FOR HZ54E-NG10
The shaded area in the diagram shows all allowable combinations of straight vertical and offset to vertical terminations, using two 90
Rigid Pipe Venting Systems for Natural Gas. Two 45
Vent must be supported at offsets.
• Firestops are required at each floor level and whenever passing through a wall.
• Maintain clearances to combustibles as listed in the "Clearances" section.
• Refer to the "Vent Restrictor Position" section for details on how to change the vent restrictor from the factory setting of Set 1 to Set 2 or Set 4
if required.
Note: Must use optional flue adaptor when using Rigid Pipe (Part # 770-994)
0
40
38
36
34
32
30
28
26
24
22
20
18
16
14
12
10
8
6
4
2
0
Minimum length of pipe
between elbows 12" (305mm)
o elbows equal to one 90
Horizontal (Feet)
2 4 6 8 10
Vent Restrictor on Set 4
Vent Restrictor on Set 2
Vent Restrictor on Set 1
(factory setting)
Max. 10' (3m)(centerline to centerline)
o elbow. Maximum of four 45
12 14 16 18 20
Please note min. 1 foot
between 90
required.
o elbows allowed.
elbows is
o
HZ54E-11 Gas Fireplace
elbows, with
o
| 7