Valve Tray Replacement - Regency LIBERTY L676-NG Owners & Installation Manual

1) Remove the exterior brick panels.
2) Remove the glass door.
a. Release the 2 door latches on the left
and right side at the top of the fi rebox.
Latch Location
Latch
b. Swing the door out from the top and release
the hinges on the left and right side of the
door by lifting them up.
Door
c. Place the door on a soft surface to prevent
scratching.
Regency ® L676 Direct Vent Gas Fireplace

VALVE TRAY REPLACEMENT

3) Loosen the 2 screws that hold the left side
heat shield in place.
4) Lift up and pull out the heat shield slightly
to clear the screwheads and then hang it
on the top bracket (located directly above
the heat shield).
Heat
Shield
Hinge
5) Unplug the power source.
6) Remove the log set.
7) Remove the interior brick panels.
8) Remove the grate by undoing the 2 screws
on the right and left side.
Grate
MAINTENANCE
9) Remove the front burner by removing the
screw.
Heat
Shield
Bracket
10) Remove the back burner by removing the
screw.
11) Remove the rear log stand by removing
the 4 screws.
Front Burner
Front Burner Removed
Back Burner
Rear Log Stand
47