Table of Contents
Advertisement
MAINTENANCE
1) Remove the exterior brick panels.
2)
Remove the glass door.
a. Release the 2 door latches on the left
and right side at the top of the fi rebox.
Latch Location
Latch
b. Swing the door out from the top and release
the hinges on the left and right side of the
door by lifting them up.
Door
3) Loosen the 2 screws that hold the left side
heat shield in place.
44
POWER MODULE REPLACEMENT
4) Lift up and pull out the heat shield slightly
to clear the screwheads and then hang it
on the top bracket (located directly above
the heat shield).
Heat
Shield
5) Unplug the power source.
6 ) Remove the top screw and loosen the
bottom screw that hold the power module
in place.
Hinge
7) Remove the power module cover by
removing the 2 screws, one on each side.
Heat
Shield
Power Module with Cover Removed
8) Remove the 3 connectors from the circuit
board.
Bracket
9) Remove the circuit board from the support
bracket by turning it around and pushing
the plastic pins with a plier.
Power
Module
10) Replace the circuit board.
11) Reverse steps to re-install.
Power Module
Regency
Circuit Board Removed
®
L676 Direct Vent Gas Fireplace
Advertisement
Table of Contents
