Epson SQ-2550 User Manual page 223

Problem
Several lines of
occur in the printout.
Skip over perforation
is set, but the skip
has shifted from the
perforation, or the
perforation does not
fall in the center
the skip.
After printing stops,
the continuous paper
forward
feeds
automatically.
When
LOAD/EJECT
button was pressed to
eject paper, the paper
paper comes
off
pull tractor sprocket
units.
Solution
You may not be using the proper paper.
Make sure to use the paper within the
specified range. Refer to 8-3.
Skip over perforation may be set. Turn
space
off the skip over perforation feature by
SelecType. Refer to 3-10.
The page length for one page of the
continuous paper may be set incorrectly.
Set the page length correctly by using
the Selectype. You can also use the ESC
C n or ESC C 0 n command to specify
the page length.
of
The loading position of the paper may
be too high or too low. Use the
micro-adjustment feature to reset the
loading position so that the perforation
is centered within the skip area.
The short tear-off function may be
selected. The short tear-off function
cannot be used with the pull tractor. Use
SelecType to turn off this function. Refer
to 3-10.
When
the paper feeds backward to eject. When
using the pull tractor, press the
the
FEED
eject.
paper select is set to Tractor,
the
button fo feed the paper forward to
FORM
Troubleshooting 7-25