Table of Contents
Advertisement
Problem
Using the pull
tractor in
combination with
the push tractor,
continuous paper
does not feed
properly.
The
FORM FEED
button was
LINE FEED
pressed, but the paper
does not feed at all.
(Platen does not
move.)
Paper feed is crooked
or the paper jams.
7-24 Troubleshooting
Solution
The printer may be on line. Before using
or
the control panel buttons to feed the
paper, always put the printer off line
LINE
Something may be obstructing your
paper supply. Make sure that the paper
can feed smoothly into the printer. Refer
to 2-8.
The supply of paper may be too far from
the printer. Position the paper supply so
that it is less than a meter away. Refer to
2-8.
The pull tractor and push tractor
sprocket units may not be aligned. Align
both tractors and resume printing.
The paper may be slack. Adjust the
position of the sprocket units to take up
any slack across the width of the paper.
Remove slack lengthwise by pressing in
and rotating the knob on the right of the
pull tractor. Refer to 5-28.
light is out.)
(ON
Advertisement
Chapters
Table of Contents
