Problem
Continuous paper
does not feed
properly.
(continued)
Regular gaps appear
in the printout.
Skip over perforation
is set, but the
perforation does not
fall in the center
the skip.
7-18 Troubleshooting
Solution
You may have pressed the
button with continuous paper already
set at the loading position. Pressing the
LOAD/EJECT
paper already loaded in the printer
causes the paper to be ejected. If this
happens, press the
once more to reload the paper. Refer to
2-14.
The skip over perforation may be set
with SelecType. Enter SelecType and
turn off the skip over perforation
feature. Refer to 3-19.
The page length for continuous paper
may not be set correctly. Change the
page length with your software
program. You can also use the ESC C n
of
or ESC C 0 n command to specify the
page length.
The loading position of the paper may
be too high or too low. Use the
micro-adjustment feature to reset the
loading position so that the perforation
is centered within the skip area.
LOAD/EJECT
button with continuous
LOAD/EJECT
button