Level 2 Options
I/F CONFIG
Use this option to configure a printer interface. The settings are
parallel for channel P and serial for channel S. This option is not
available for channel O.
The PARALLEL option has these three submenus:
Normally, you do not need to change these settings. Change them
only when you have special requirements.
SLCTIN — When you set SLCTIN to OFF, the printer is
l
continuously selected and ignores device control codes DC1
and DC3. In almost all cases, leave SLCTIN set to OFF. When
SLCTIN is ON, the SLCTIN signal goes HIGH at power-on
and the control codes DC1 and DC3 are valid.
3-24
SelecType
Menu/submenu
Menu/submenu
Menu/submenu
Available options
P (Parallel)
S (Serial)
Available options
SLCTIN
AUTOFEED
BUSY DELAY
Available options
ON or OFF