Epson EPL-8000 User Manual page 217

5. Grasp the board with both hands and pull it straight out of its
slot.
6.
Set the controller board on a clean, stable surface with the
bracket (connector) facing to your right and the components
facing up.
7. If you have installed an optional interface card, you must
remove it before you can install a memory chip set on the
controller board. Grasp the interface card and pull it straight
out of the interface slot.
Note:
If you are installing chip sets on the controller board, you
may want to remove the plastic guide rail above the RAM chip
sockets. To do so, release the two tabs that secure the guide rail
and lift it off the board. Replace the rail after you install the
chips.
Memory Options
7-27
Options