Timeout - Epson EPL-8000 User Manual

2
Level Options
Note: You can also save the settings with the P-CONFIG SAVE
option, and then initialize the printer. See the P-CONFIG SAVE
option later in this chapter.

TIMEOUT

This option is available only when the PostScript card is installed.
Use this option to specify the time (in seconds) for intelligent
emulation switch timeout. When the intelligent emulation
switching channel receives no more data, it enters the timeout
status. During the timeout it cannot switch to another mode;
instead, it prints all data received in the current mode. You can tell
when the timeout is over by the display, which switches from
showing READY and the current mode to showing PS and the
other selected mode. For example, if LJ-3 is the other selected
mode, the display shows READY LJ-3 during the timeout and
PS&LJ-3 after the timeout. Do not send any data in the new mode
until the display changes. You can set a different timeout value for
each mode. The factory setting is 30 for PS mode and
(other). This option is available only when an IES setting is
selected.
Press the
change the setting; then press
For complete instructions on the intelligent emulation switch, see
Chapter Switching the emulation mode.
2,
3-34 SelecType
Menu/submenu
button to select the mode for which you want to
Menu/submenu
10
Available options
PS or OTR
Available options
to (in steps of
5 95
for OTR
5 )