Epson EPL-8000 User Manual page 99

The setting you can select for the RX-BUFFER SIZE varies
depending on the amount of total RAM size in your printer. The
table below shows the available settings for the buffer sizes. X is
the amount of RAM that the printer has.
If you have not installed any additional memory in your printer,
the factory setting is 5KB.
Press to increase the buffer size or
the buffer briefly to change the value
button down to change the value rapidly.
After changing the buffer size, you need to execute SAVE&INIT
for the new setting to take effect. Press
cancel the save and initialize operation.
Note:
You can also save the settings with the P-CONFIG SAVE
option, and then initialize the printer. See the P-CONFIG SAVE
option later in this chapter.
Menu/submenu
to decrease it. Press
at a time or hold the
1K
to execute or
Available options
< or >
SelecType
Level 2 Options
to
3-31