Sony Handycam DCR-PC9 Operating Instructions Manual page 78

Dubbing only desired scenes - Digital program editing
To edit using the VCR, send the control signal by infrared rays to the remote sensor on
the VCR.
When you connect using the A/V connecting cable, follow the procedures below, (1) to
(4), to send the control signal correctly.
(1) Setting the IR SETUP code
@ Set the POWER switch to VCR olr your camcorder.
@ Turn the power of the connected VCR on, then set the input selector to LINE.
When you COlmect a video camera recorder, set its power switch to VCR/VTR.
@ Press FN to display PAGE1.
@ Press MENU, then select EDIT SET in _ in the menu settings (p. 105).
Then press EXEC.
@ Select CONTROL, then press EXEC.
@ Select IR, then press EXEC.
@ Select IR SETUP, then press EXEC.
@ Select the IR SETUP code of your VCR, then press EXEC. See the following
page about the IR SETUP code.
3
5
6~8
r_
r_
78