Non-Isolated High Speed Counter Input Module; Non-Isolated Mixed Input/Output Module - Emerson ControlWave EFM 4710A Instruction Manual

Terminations:

4.4.3 Non-isolated High Speed Counter Input Module

Number of Inputs:
Input Configuration:
Input Frequency:
Input filtering:
Signal Conditioning:
'1' State Voltage:
'0' State Voltage:
Bus Access:
Electrical isolation:
Surge Suppression:
Terminations:
Status Indication:
Power Consumption:

4.4.4 Non-isolated Mixed Input/Output Module

Number of I/Os:
4-6 / Specifications
mA @ 3.3Vdc: 12 DIs ON @ 66uA, CLK active
4.4
27.6mA @ 3.3Vdc: 12 DIs ON @ 2mA, CLK active
Status LEDs Enabled
All DIs and DOs OFF: 33uA
All DIs and DOs ON: add 32mA
Pluggable, max wire size is 14 gauge for local terminations -
Two 14-pin mass termination headers are provided for
remote terminations
4 HSC Inputs per Module
Internally Sourced Dry Contact, individually Jumper
selectable Debounce Circuitry and individually Jumper
selectable input current of 200uA or 2mA
10kHz Max.
20 microseconds
Debounce circuit for contact closures and bandwidth
limiting
below 1.5V
above 1.5V
Eight Bits Wide
None
31V Transorb between signal and ground
Meets ANSI/IEEE C37.90-1978
Pluggable, max wire size is 14 gauge for local terminations -
Two 14-pin mass termination headers are provided for
remote terminations
4 LEDs (one per point)
3.9mA IOCLK stopped (All Inputs OFF)
6.8mA IOCLK running (All Inputs OFF)
Additional Current per Input
200uA or 2MA per HSCSET or HSCRST Input (ON State)
2mA per ON LED
33uA for LED circuitry
6 jumper configurable DI/DOs per Module
4 Analog Inputs per Module
CI-ControlWave EFM