Advertisement
Terminations:
Data Transfer:
4.4.2 Non-isolated Digital Input/Output Module
Non-isolated Digital Inputs
Number of Inputs:
Input Filtering:
Input Current:
'0' State Voltage:
'1' State Voltage:
Bus Access:
Electrical Isolation:
Surge Suppression:
Status Indication:
Non-isolated Digital Outputs
Number of Outputs:
Output Configuration:
Maximum Load Current:
Bus Access:
Electrical Isolation:
Surge Suppression:
General DI/DO Module Specs.
Power Consumption:
CI-ControlWave EFM
Note
: 2.5 ohm uncompensated series resistance with
2
Inductors
Pluggable - Max. wire size is 14 gauge
8 Bit Wide bus access
12 DI individually jumper configurable for 2mA or 60uA
Internally Sourced (Dry Contact) operation
15 milliseconds
Jumper configured for 2mA or 60uA nominal
below 1.5V
above 1.5V
Eight Bits Wide
None
31V Transorb between signal and ground
Meets ANSI/IEEE C37.90-1978
12 LEDs (one per point)
4 DO
Open Drain (Externally Powered)
100mA @ 31Vdc
Eight Bits Wide
None
31V Transorb between signal and ground
Meets ANSI/IEEE C37.90-1978
Status LEDs Disabled
1.3mA @ 3.3Vdc: 12DIs OFF, CLK stopped
2.1mA @ 3.3Vdc: 12DIs ON @ 66uA, CLK stopped
25.3 @ 3.3Vdc: 12DIs ON @ 2mA, CLK stopped
3.6mA @ 3.3Vdc: 12DIs OFF, CLK active
Specifications / 4-5
Advertisement
Chapters
