3,000-sheet stapler/stacker and 3,000-sheet stacker assemblies
Flipper assembly
1
2
CAUTION
To prevent damage to the flipper motor, use the long-bit Torx #20 screwdriver to remove the top
right mount screw. The long-bit Torx #20 screwdriver is shipped with the flipper assembly.
3
Figure 104.
Flipper assembly
4
5
ENWW
Remove the following FRUs:
• Face-up bin. See page 129.
• Stapler/stacker bin. See page 129.
• Back inner cover. See page 130.
• Front inner cover. See page 130.
• Front cover. See page 131.
• Back cover. See page 132.
Unplug the flipper ribbon cable (callout 1) by pressing the black tabs on the cable connector.
Use a Torx #20 screwdriver to remove four mount screws (two shown, callout 2).
Grasp the flipper assembly on each side, and lift it up to clear the tabs.
Remove the flipper assembly.
2
2
1
2
2
2
Chapter 6 Removal and replacement 137