Performing Calibration And Adjustment; Multifunction Finisher; Figure 184. Booklet Adjustment-Multifunction Finisher - HP Color LaserJet 9500 Service Manual

Performing calibration and adjustment

Multifunction finisher

Performing booklet adjustment by using the control panel
1
2
Figure 184. Booklet adjustment—multifunction finisher
3
4
5
Note The control panel shows the distance of "d" in millimeters only.
244 Troubleshooting
Print a one-sheet booklet.
Measure the distance "d" (see figure 184).
Front
cover
d (+)
On the control panel, touch Configure Device, touch Multifunction Finisher, and then
touch the menu item that corresponds to the paper-size of the booklet that should be
adjusted:
• Fold line adjust LTR-R and A4-R,
• Fold line adjust LEGAL and JISB4, or
• Fold line adjust 11x17 and A3
Choose a positive value for adjustment if the front-page edge (usually the front cover of a
booklet) is smaller than the back page. Choose a negative value for adjustment if the front
page edge is larger than the back-page edge.
Repeat the procedure to test the adjustment.
Front
cover
d (-)
ENWW