Controller PCA
Note
See figure 117 for the stapler/stacker or figure 118 for the stacker.
1
2
3
4
Figure 117.
Stapler/stacker controller PCA
150 Removal and replacement
Remove the following FRUs:
• Face-up bin. See page 129.
• Stapler/stacker bin. See page 129.
• Back inner cover. See page 130.
• Back cover. See page 132.
• Controller PCA cover. See page 135.
Stapler/stacker: Unplug four ribbon cables, the power cable, and the LED cable (figure 117,
callout 1).
Stacker: Unplug three ribbon cables, the power cable, and the LED cable (figure 118,
callout 1).
Loosen two connector screws (callout 2) on the Jet-Link cable, and then disconnect the
cable.
Use a Torx #20 screwdriver to remove four mount screws (callout 3), and lift the controller
PCA out of the output device.
3
2
1
2
3
2
2
2
ENWW