3
4
5
Figure 53.
Front cover (2 of 2)
Reinstall note
CAUTION
Before you reinstall the product-release handle, move the internal latching mechanism toward the
left side of the multifunction finisher, and align the spring correctly (see figure 49 on page 93). If
the product-release handle is not reinstalled correctly, the multifunction finisher will no longer
detach from the printer.
ENWW
Remove six more screws (callout 2) from the front cover.
Pull one tab (callout 3) downward to release it.
Lift the lower section of the cover upward to release two internal tabs (callout 4), and remove
the cover.
4
2
2 3
2
2
Chapter 6 Removal and replacement 97