Adjustable casters (left side)
Note
For safety, first remove the stapling unit (see page 104), and then gently lay the multifunction
finisher on its side. (Figure 93 shows the multifunction finisher in an upright position.)
Front left caster
1
2
3
Back left caster
1
2
3
Figure 93.
Adjustable casters
126 Removal and replacement
Remove the front cover. See page 96.
Remove the e-clip (figure 93, callout 1) from the metal pin.
Slide the caster shaft out, and remove the caster.
Remove the back cover. See page 98.
Remove the e-clip (callout 1) from the metal pin.
Slide the metal pin out, and remove the caster.
2 1
ENWW