Casters; Figure 128. Stationary Caster; Figure 129. Adjustable Caster - HP Color LaserJet 9500 Service Manual

Casters

Stationary caster
1
2
3
Figure 128. Stationary caster
Adjustable caster
1
2
3
Figure 129. Adjustable caster
ENWW
Lay the output device on its front or back side, so that the caster being replaced is off of the
floor.
Use a Torx #20 screwdriver to remove one screw (callout 1) from the inside of the frame.
Rotate the caster 90° to clear the tabs, and then pull the caster away from the output device.
2 1
Lay the output device on its front or back side, so that the caster being replaced is off of the
floor.
Use a flatblade screwdriver and snap the e-clip off of the adjusting knob.
Slide the caster out of position and remove it.
Chapter 6 Removal and replacement 159