Data Cable - DataCard ImageCard Select User Manual

4-12
6
7
Remove the printhead cables.
– Push the black locking tabs to the side. Remove the gray connector of the
printhead data cable from the printhead cartridge (see Figure 4-11).
– Pull firmly on the white connector of the printhead power cable to remove it
from the printhead cartridge. You can gently pull on the wires attached to the
plug if needed to remove the cable.
Figure 4-11: Printhead power and data cables and connectors
Remove the ground cable connector from the ground tab of the swing arm by
pulling on the red sleeve (see Figure 4-12).
Figure 4-12: Printhead ground cable
User's Guide for ImageCard® Select™ and UltraGrafix® Select™
Power cable

Data cable

Ground cable
Maintaining the printer