Powering On The System - DataCard ImageCard Select User Manual

2-6
Replace the print ribbon cartridge
1
2
3

Powering on the system

Use the following procedure to power on the printer and attached PC.
Power on the printer
i
1
2
3
4
Place the ribbon cartridge onto the ribbon cartridge supports (see Figure 2-9).
Make sure the cartridge is securely seated. Avoid touching the printhead cartridge
and ribbon tracker.
Figure 2-9: Replace the print ribbon cartridge
Close the swing arm, pressing it down until the push latch clicks into place.
Close the cover.
If the printer is connected over a network using a print server, see the SmartDriver
Direct Network Installation and User Guide for more information about powering
on the printer.
Make sure cards and all other supplies are loaded. See other sections of this
chapter for more information.
Remove any printed or rejected cards from the output stacker.
Make sure the power cord and data cable are connected. If needed, see
"Connecting cab les" on page 7-3 for more information.
Press the printer Power switch to turn on power. Observe the printer status light
which lights with a sequence of colors and then becomes steady green. See
"Status light" on page 2-7 for more information. The printer initializes components
and makes audible sounds.
User's Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
Using the printer