Epson STYLUS Scan 2000 Service Manual page 92

EPSON Stylus Scan 2000
4.2.4.4 Removing the scanner motor
1. Remove the scanner as described in "Removing the Scanner
Mechanism" on page 88.
2. Cut the plastic clip securing the cables.
3. Remove two screws (CBP 3x6 with plain washer).
Remove two
screws.
Make sure the motor cable wraps around the back of the
motor, as shown in step 2.
Replace the cables with a new plastic clip when
reinstalling the scanner motor as shown in steps 2 and 3.
Disassembly & Assembly
Motor
cable
Cut this
clip.
Disassembly Procedures
4.2.4.5 Removing the upper frame
Removing the upper frame can make some procedures such as removing the
printhead easier, but is not required.
1. Remove the upper cover as described in Section 4.2.1.4.
2. Remove the scanner as described in "Removing the Scanner
Mechanism" on page 88.
3. If you have not already removed it, remove one screw (CBP 3x6) securing
the carriage guard and then remove the guard. Also remove two screws
(CBP 3x6) securing the upper frame on the left side.
When re-
installing
the gear
cover, insert
this knob
into the
upper hole.
Gear
cover
First remove this
screw and the
gear cover.
Revision A
Then remove
these screws.
92