Epson STYLUS Scan 2000 Service Manual page 80

EPSON Stylus Scan 2000
4.2.1.4 Upper cover
NOTE: Before removing the upper cover, you may wish to remove
the control panel as described in the previous section. If you
do not remove it first, keep in mind that you need to remove
the control panel FFC during step 4 below.
1. Remove two screws from the front (CBS 3x6).
Screws (CBS 3x6)
2. Remove two screws from the back (CBS 3x6).
Screws
(CBS 3x6)
Disassembly & Assembly
Scanner cover
Disassembly Procedures
3. Open the scanner cover, and pull the upper cover to the rear to remove its
projection from under the scanner's edge (black); then release so the upper
cover is above the scanner's edge.
4. Move the carriage back to the home position and lift up the upper cover
and remove it.
Figure 4-1. Upper cover (from front)
Revision A
2
1
80