Epson STYLUS Scan 2000 Service Manual page 131

EPSON Stylus Scan 2000
Table 6-2. Lubrication Points (continued)
No. Standard
<Lubrication Point>
Oil pad in the carriage assembly
<Lubricant Type> O-12
<Lubrication Amount>
12
0.72 ~ 0.77cc (0.65 ~ 0.69g)
Note:
This is the amount to be applied to
a new oil pad.
Maintenance
Remarks
Lubricate the oil pad only when:
Replacing the carriage assembly
Replacing the oil pad
Use a precise syringe to apply oil.
If you accidentally apply too much
oil to the oil pad, throw the pad
away and take a new one again.
Leave the pad for a while to wait
until oil is evenly infiltrated, then
install it on the carriage assembly.
See
page
136
Figure 6-1. #1 Paper Feed Roller x two places
When rotating the Paper Feed Roller, only touch the
projections on the outside surface of the 73.6 precision
gear. Do not touch the teeth of the gear.
Lubrication
Revision A
G-26
ROLLER, PF UNIT
G-26
ROLLER, PF
131