Removal Of Printer Consumables - Epson STYLUS Scan 2000 Service Manual

EPSON Stylus Scan 2000

4.2.2 Removal of printer consumables

The printer consumables consist of the waste ink pads (described below) and
cleaning assembly (described in "Removing the cleaning assembly (Pump
and Cap)" on page 82).
4.2.2.1 Removing the waste ink pads
1. Remove the front cover assembly as described in Section 4.2.1.1.
2. Remove one screw (CBP 3x8) securing the waste ink tank and which is
located on the right side of the printer mechanism.
Spacer
Figure 4-2. Removing the waste ink tank
Disassembly & Assembly
3. Remove the spacer on the left side of the tank and carefully pull the tank
4. Remove one screw (CBP 3x10) securing the waste ink tank cover, and
5. Carefully remove the old waste ink pads so as not to get yourself or
One CBP 3x8
screw
Waste ink tank
Disassembly Procedures
out and downward.
When re-installing the waste ink tank, make sure to secure the
hooks on the left of the tank on top of the spacer.
After replacing the waste ink pads, reset the waste ink
counter.
then remove the cover by lifting up from the center.
anyone/anything else dirty.
Figure 4-3. Waste ink cover, pads, and tank
Revision A
81