EPSON Stylus Scan 2500
Table 5-2. List of Required Adjustments
No.
Adjustment Item
• When you replace or remove the carriage or
1
Parallelism Adjustment
• When you move the parallelism adjustment
• When you replace or remove the printhead.
2
Initial Ink Charge
• When you replace the printhead.
• When you replace the main board.
3
Head Voltage ID Input
Note) The values stored in this address are not
• When you replace or remove the printhead.
• When you move the printhead angle-adjust
Printhead Angle
4
Adjustment
• When you replace or remove the carriage or
• When you replace or remove the printhead.
• When you replace the main board.
5
Bi-D Adjustment
• When you replace the CR Motor.
• When you replace or remove the carriage or
• When you replace the waste ink pads.
Reset waste ink
6
counter.
Table below shows the actions taken and required adjustments in the order to
be performed.
Adjustment
Conditions
carriage guide shaft.
bushing.
erased by the EEPROM reset operation.
lever.
carriage guide shaft.
carriage guide shaft.
Required Adjustments
Revision A
109