Epson STYLUS Scan 2000 Service Manual page 78

EPSON Stylus Scan 2000
When reinstalling the front cover assembly, make sure the
pegs at the bottom of the lower covers are visible through the
holes in the waste ink tank. If some pegs are not visible, the
pegs are bent and a lower cover has not been installed
correctly.
Three sets of three pegs each.
Disassembly & Assembly
4.2.1.2 Rear cover
1. Remove three screws (two x CBP 3x8 and one x CBS 3x6).
2. As shown below, evenly pull the rear cover down (#1) and out (#2) to
remove it. (Try this over the edge of your desk if you have difficulty.)
Disassembly Procedures
Two Screws
(CBP 3x8)
One screw
(CBS 3x6)
1
2
Revision A
78