Epson STYLUS Scan 2000 Service Manual page 91

EPSON Stylus Scan 2000
4.2.4.3 Removing the ASF (paper end) sensor
1. Remove the scanner as described in "Removing the Scanner
Mechanism" on page 88.
2. Open the scanner cover and remove two screws (CBP 3x6).
3. Using a flat-tip screwdriver or similar tool, push out the sides of scanner
cover's sides so the cover comes free from the notches.
4. Remove three silver screws (CBP with flange 3x6) plus the grounding
plate, one screw (CBP with flange 3x6), and two black screws (CBP 3x6)
securing the ASF (paper end) sensor.
Remove one screw
5. Remove the sensor.
Disassembly & Assembly
Two screws
Notches on
sides of cover
Remove three
screws and
grounding plate.
Two screws
Disassembly Procedures
When replacing the scanner cover assembly, make sure you
remove the blue protective tape that covers the standard-
white strip during ASP transport.
Blue Protective tape
The scanner performs a standard-white test during every
initialization and if the blue protective tape is not removed,
scanned output will appear like a 1950's era 3-D movie -
without the glasses. In other words, blurry.
Revision A
91