Epson STYLUS Scan 2000 Service Manual page 105

EPSON Stylus Scan 2000
4.2.5.8 Removing the PE Paper Detector Assembly
1. Remove the housing. (Refer to Section 4.2.1.)
2. Move the carriage out of the home position.
3. Release two fixed hooks securing the PE detector assembly from the back
of the frame and remove the PE detector assembly, sliding it upward.
Remove the PE board assembly and PE lever, if necessary.
During assembly, make sure that the tip (sensor part) of the
detector lever is in the hole of the paper guide assembly.
Disassembly & Assembly
After releasing two hooks, remove
the PF paper detector assembly,
This side should
be installed on the
frame.
PE Board
Assembly
Figure 4-19. Removing the PE Detector Assembly
Disassembly Procedures
sliding it upward.
PE Holder
Torsion Spring 0.22
Revision A
(From back side of
the frame)
PE Lever
105