Epson STYLUS Scan 2000 Service Manual page 124

EPSON Stylus Scan 2500
Figure 5-9. Screw Position
NOTE: Make sure to loosen this screw. Otherwise, the printhead
angle will not change even if the adjustment lever moves.
5. Look very closely at the black/magenta lines in the bottom pattern and
move the adjustment lever to center the magenta lines between the black
lines. The figure below shows how to move the lever to correct a
misaligned pattern.
Adjustment
Printhead
securing screw
6. After changing the position of the adjust lever, select Print - Angular Adj.
7. Verify the pattern on the printout again.
8. Repeat this process until the combination pattern of black/magenta is
9. After completing the adjustment, tighten the printhead screw, and
Using the Service-Adjustment Program
Correct condition = vertical
spacing is even
To move this up
Move the lever
to the front
Figure 5-10. Lever Operation
again from the Production Menu.
correct.
reassemble the Stylus Scan.
Revision A
To move this down
Move the lever
to the rear
Adjustment lever
124