Epson STYLUS Scan 2000 Service Manual page 90

EPSON Stylus Scan 2000
4.2.4.2 Removing the lamp
1. Remove the scanner as described in "Removing the Scanner
Mechanism" on page 88.
2. Open the scanner unit and pull the cables free from the slot on the right
side.
3. Fully open the scanner cover and remove the right and left cover
projections. Then remove two black screws (CBP 3x6) from the document
path..
Remove the cover
and two screws.
Disassembly & Assembly
Pull out
these cables
from the
notch here.
Disassembly Procedures
4. Lift up the document guide as shown below, and remove it.
Protective film
When reinstalling the document guide, make sure the
protective film slides under the forward rollers.
5. Lift from underneath both ends of the lamp assembly (lamp, cable, and
lamp support) to remove it. The lamp assembly snaps in and out.
6. Turn over the scanner mechanism so you can see the circuit boards. Pull
the lamp cables out of the two black hooks and remove the lamp
connector. Then pull out the cable and connector.
Two black
hooks
Revision A
Lamp connector
90