End Position Of The Sewing Machine - Duerkopp Adler 558 Operating Instructions Manual

2.3 End Position of the Sewing Machine

–
Turn handwheel 2 until it catches.
The needle is in its highest position.
–
Turn the hand crank until the clamp closing lever 1 automatically opens the clamp
arms.
Depending on the setting of the machine to cutting before or after sewing opening
occurs before or after operation of the cutter bar 3.
–
The machine is in the end position.
ATTENTION !
Before turning the hand crank it is essential that the needle
be brought into its high position by moving the handwheel
into its catch.
A bending of the needle or damage to the material is thus
avoided.
Exception:
The handwheel may not, however, be turned at that
moment in which, after the end of the sewing sequence,
the cutting movement of the upper thread knife begins and
this lies under the needle hole of the needle plate.
3
23