Marker Lights - Duerkopp Adler 745-22 Service Instructions Manual

5. Marker Lights

1
111
1 : Needles
2 : Light marker-forward positioning point
3 : 3rd marker light (on request)
20
The light markers 2 and 4 limit the sewing area.
Alternatively a 3rd marker light, available on request, can be attached
(Order no. 793 022068).
The multiple masks built into the lamp optics make possible the
following application:
–
Because of the small H-light markers a clearance of 10 mm
between chest dart and flap edge can be achieved in the
positioning of jacket fronts.
By setting the marker lights higher the clearance can be increased
to a maximum of 15 mm.
–
Turn the marker light 90°.
Clearances from 15 mm to a maximum of 25 mm can be set by
setting the large H-light marker higher or lower.
2 3
10
180
After setting the marker lights higher or turning them it is essential that
the following points be observed:
–
Reset the lamp holder.
–
Align the light markers congruent to the center of the pocket
opening.
–
Keep to the maximum sewing area.
Focusing the light markers sharp
–
Loosen clamping screw 13 slightly.
–
Focus the light marker sharp by setting the tube 14 higher or lower.
–
Tighten clamping screw 13.
4
10
4 : Light marker-rear positioning point
5 : Center of the pocket opening
6 : Measurement line
5
6