Cueing Function; Repeat Function; Auto Play Function; Power On Play Function - Fostex UR-2 Owner's Manual

Model UR-2 <Playback>

Cueing function

During playback, you can use the [
[ REW] key to enter cueing mode, in which
you can cue (fast wind while monitoring audio)
forward or backward at up to eight times the
normal speed.
MENU / ENTER
FILE/CURSOR
Y EXIT
MRGN RST PREV CUE NEXT
PLAY F FWD
STOP REW
ABS 0
REC END
[ REW] key
[
Each press of the [
<Memo>:
REW] key changes the cueing speed among two,
four, six and eight times the normal speed. While
cueing is being performed, the display shows any
of the following icons.
The number of
REW direction
key press
One
Two
Three
Four
Five
The cueing speed at six or eight times
<Note>:
the normal speed is available only for a file
with 48 kHz FS or lower sampling frequency.
<Memo>: By default, playback audio while cue-
ing is output from the [ANALOG OUT], [DIGITAL
OUT] and [PHONES] connectors, therefore, you
can monitor it using headphones or external
monitor speakers. However, you can output au-
dio only from the [PHONES] connector using the
"Cue Monitor Out" item in the SYSTEM SETUP
menu of the MENU mode. If you do not wish to
output cueing audio from PA speakers, use this
setting (see page 77 for details).
F FWD] or
PHANTOM
CUE/LOCATE MIC IN
TIME EDIT MIC SET
MIN MAX MIN MAX
INPUT LEVEL MIC GAIN MIC IN
F FWD] key
F FWD] or [
FWD direction

Repeat function

By setting the repeat function to "On", the unit
repeats playback in the current playback mode
until you press the [STOP] key.
You can turn on or off the repeat function by
pressing the
SHIFT
followed by the [TIME]/[
is stopped.
[
SHIFT
SHIFT
AUTO PLAY
EJECT
READY
SD-1 SD-2
<Memo>: You can also turn on or off the repeat
function using the "Repeat" menu item in the
PLAY SETUP menu of the MENU mode (see page
57).

Auto play function

By setting the "Auto Play" menu item in the PLAY
SETUP" menu of the MENU mode to "On", the
unit automatically start playback after skipping
to a desired file using the [
ing playback (or after directly locating a marked
position using the numeric keys of a USB key-
board).
By default, the "Auto Play" menu item is set to
"On" and the [AUTO PLAY] indicator on the front
panel is lit.
[AUTO PLAY] indicator
AUTO PLAY
HOST
SD-1
See "PLAY SETUP menu details" on page
<Memo>:
57 for details about the "Auto Play" menu item.
If you use the [
<Memo>:
stopped to skip to a desired file, the unit stops at
the beginning of the file without automatically
starting playback even if the "Auto Play" menu
item is set to "On".
-54-
key to turn on the shift mode
] key while the unit
REPEAT
] key
[ ] key
REPEAT
PLAY
MODE TIME
EDIT REPEAT
FILE SEL DISPLAY
UR-2
STEREO RACK MEMORY RECORDER
STRG SEL
] or [
PLAY
SHIFT MODE TIME
EDIT REPEAT
EJECT
FILE SEL DISPLAY
READY
SD-2
UR-2
STEREO RACK MEMORY RECORDER
STRG SEL
] or [ ] key while
REC RDY EXIT
MRGN RST
REC STOP
ABS 0
REC END
] key dur-
REC
R